Product Application Interior
Bristol Finish Classic Clear Water Based Urethane requires the same basic prep as ordinary coatings, but the application is both easier and faster. Save almost 75% of the labor compared with ordinary coating products!
Preparation Procedures
New or Bare Wood: Sand as required up to 220 grit. Remove dust and wipe with acetone. Wipe with a tack rag. Apply 1 or 2 coats of any commercial sanding sealer, following manufacturer�s instructions. Sand as required to level raised grain. Remove dust and wipe with a tack rag.
Previously Finished Surfaces: New coatings should be allowed to cure fully before over-coating with Classic Clear Water Based Urethane. Check compatibility on a small area before coating large areas.
Sand with 220 grit until smooth and dull. Use a red ScotchBrite pad for sharp corners and edges. Remove dust with a clean damp towel, then lightly wipe with a tack rag.
Application Procedures
Stir thoroughly before using. Use bristle or foam brushes, rollers or spray equipment. Use a floor coating applicator for large flooring areas. Apply a thin even coat with the grain of the wood. Allow to dry for a minimum of 1 hour. Apply a second coat when the first coat is not tacky. If grain raising has occurred or first coat has dried longer than 4 hours, sand with 220 grit. Remove dust with a clean damp towel, then wipe with a tack rag, and apply the second coat. More coats may be applied if desired.
Clean equipment thoroughly with water. Clean up spills immediately
Compatibility
Apply over wood stains, sealers, and existing finishes if in good condition. Oil finishes or wax must be removed.
Application Methods
Suitable for brush, roller or spray
Recoat Time
1 to 4 hours at 70�F (21�C)
|