• ILMDL-CONKITL6 - AC plug at the power source end allows you to plug 3/8" Incandescent rope light into a 115V AC wall socket
• ILMDL-CONKIT-6 - Bare wires at the power source end allows you to connect 3/8" LED rope light to a 12 or 24V DC power source - e.g. a bus bar, etc.
Unscrew the compression end fitting and slide it over the rope light.
Insert the 2 pins on the power cord into the rope light, making sure they line up with the wires in the rope light.
Slide the compression fitting down to the power cord, and screw down tight. Done!
Installation Note:
Before you install your LED rope lights, connect the power and verify illumination. Then as you do your installation, beware of which end you need to feed the power to. LED rope lighting contains diodes that allow the electricity to flow in one direction only. Because of this, when you hook up power to the LED rope lighting, it may not illuminate. If this is the case, disconnect the power and reconnect it to the other end of the LED rope lighting.
